# to get hard land/water transitions which # FS9 users: Use water_blending=off, water_smoothing=on # Recommendation: FSX users: Use water_blending=on, water_smoothing=off # option off, you get the Tileproxy behavior of Beta 5 and earlier versions. # for the use of planes with floats (Goose, Beaver, etc.). This brings back shader-rendered water and allows # you run out of RAM during flight and the PC starts to use the paging file a lot. # mean more use of your precious kernel memory though. Each tile context can hold an entire LOD 8.15 tile. # is essentially a very fast buffer for graphics data sitting in kernel memory that delivers # The maximum number of tile contexts that Tileproxy will send to the filter driver. # Lowest LOD ring to automatically preload tiles for. You can then instruct Tileproxy to not preload these low resolution LOD circles because # scenery library then it will have precedence over Tileproxy for the specific LOD levels that it If you place this scenery higher than Tileproxy's world folders in the # be used in conjunction with third party scenery products like "FS Altitude" that provides data only # The following two settings allow you to tune Tileproxy to not preload specific LOD levels. # if you have at least 2GB of system memory. # Lower resolutions load faster, but are visually less appealing. # Offline Mode - No network access will occur (Yes/True/On to enable) # Note that offline mode will depend on tiles being available in the cache. # will not store a single tile on your hard drive. # on your hard drive, this switch is the solution. # If you have concerns about possible copyright violations by caching JPEG and BMP tiles # When using FSX RTM or FS 2004, the logfile will grow VERY fast and affect performance. In recommend to only turn this on for debugging purposes. # Enable or disable worldwide photographic scenery coverage (Yes/True/On to enable) # author about the configuration for particular services. # Read the manual for help with configuration. # Turn your text editor's Word Wrapping OFF for editing this document. I cant get my ini file rite to work with google maps can someone fix my ini file if i post it on here thanks! When i load fsx with tile proxy all i see is black ground? I have tileproxy cache installed on just C:\
0 Comments
Leave a Reply. |